oventrop DynaTemp FM-C WS Bedienungsanleitung Seite 4

9 Dimensions
10 Installation
The field module is to be installed at a location which is not
exposed to other heat sources, such as direct sunlight. When
using an outside temperature sensor, it should be installed on
the north side of the building. The field module "FM-C WS" does
not require an own power supply, energy is supplied via the bus
line. The housing must only be fixed at the designated fixing
points. Do not drill through the rear wall of the housing. Before
work commences, please ensure that the appliance is discon-
nected from the power supply. The electrical connection must
only be carried out by a qualified electrician.
Screw the housing only to the fixing points. Do not drill through
the rear wall of the housing.
11 Drill hole dimensions
12 Pin assignment
Designation
Terminal X1
1 A
2 B
3 -
4 -
- 2 -
Description
Permissible cable cross sections:
0,2 mm² ...1,5 mm²
C-B-bus, bus interface
-
-