Connecting the Device
Turn On the Camera
Insert the power supply cable into the camera's power supply port. Connect the other
end of the power supply cable to a power source,
Indicator Light
Blue light on: connected/device status is normal
•
Blue light flashing: network error
•
Orange light flashing rapidly: waiting for connection
•
Orange light flashing slowly: system upgrade in progress
•
Inserting a Micro SD Card
Ensure that the camera is disconnected from the power supply. Use a screwdriver to
remove the protective case and expose the micro SD card slot. The contact points of the
micro SD card should be facing the same direction as the camera. Insert the micro SD
card into the slot.
Note: When inserting or removing the micro SD card, please disconnect the camera
from the power supply. Please use a micro SD card from a reputable manufacturer. The
recommended read and write speed of the micro SD card is at least U1/Class 10.
Resetting Factory Settings
Press and hold the reset hole with fine needle, then you can hear the "reset succeed"
voice prompt. Data stored on the MicroSD card are not deleted.
6