Connecting The Device; Turn On The Camera - imilab EC3 Benutzerhandbuch

Connecting the Device

Turn on the camera

Step 1: Insert the power supply cable into the camera's power supply port. Connect the
other end of the power supply cable to a power source.
Step 2: When connected to a power supply, the indicator light will show the camera's
status. When the indicator light is yellow, the camera is being turned on; when the
indicator light is flashing yellow, it is waiting to be connected.
Insert a micro SD card
Ensure that the camera is disconnected from the power supply. Use a screwdriver to
remove the protective case and expose the micro SD card slot.
The contact points of the micro SD card should be facing the same direction as the
camera. Insert the micro SD card into the slot.
Micro SD Card Slot
Note:
When inserting or removing the micro SD card, please disconnect the camera from the
power supply. Please use a micro SD card from a reputable manufacturer. The
recommended read and write speed of the micro SD card is at least U1/Class 10.
10