IKEA LAGAN Bedienungsanleitung Seite 5

ENGLISH
available on the electrical installation.
• Do not touch the plug with wet hands.
• When unplugging the appliance, do not
hold the power cord, but the plug.
HANDLING SAFETY
• This product is heavy, do not handle it by
yourself.
• Do not move the product by holding the
door.
• Be careful not to damage the cooling
system and the pipes while handling the
product. Do not operate the product if
the pipes are damaged, and contact an
authorized service.
INSTALLATION SAFETY
• To prepare the product for installation,
see the information in the user guide and
make sure the electric and water utilities
are as required. If the installation is not
suitable, call a qualified electrician and
plumber to have them make the necessary
arrangements. Otherwise, electric shock,
fire, issues with the product or injuries may
occur.
• Check for any damage on the product
before installing it. Do not have the
product installed if it is damaged.
• Place the product on a level and hard
surface and balance with the adjustable
legs. Otherwise, the refrigerator may tip
over and cause injuries.
• The product shall be installed in a dry
and ventilated environment. Do not keep
carpets, rugs or similar floor covers under
the product unless recommended by the
supplier. This may cause risk of fire as a
result of inadequate ventilation!
• Do not block or cover ventilation holes.
Otherwise, power consumption may be
increased and damage to your product
may occur.
• Do not connect the product to supply
systems such as solar power supplies.
Otherwise, damage to your product may
occur as a result of the abrupt voltage
fluctuations!
• The more refrigerant a refrigerator
contains, the bigger its installation room
shall be. In very small rooms, a flammable
gas-air mixture may occur in case of a gas
leak in the cooling system. At least 1 m³
of volume is required for each 8 grams of
refrigerant. The amount of the refrigerant
available in your product is specified in the
Type Label.
• The installation place of the product shall
not be exposed to direct sunlight and it
shall not be in the vicinity of a heat source
such as stoves, radiators, etc.
If you cannot prevent installation of the
product in the vicinity of a heat source, you
shall use a suitable insulation plate and the
minimum distance to the heat source shall be
as specified below.
- At least 30 cm away from heat sources such
as stoves, heating units and heaters, etc.,
- And at least 5 cm away from electric ovens.
• Your product has the protection class of
I. Plug the product in a grounded socket
that conforms with the Voltage, Current
and Frequency values specified in the type
label. The socket outlet shall be equipped
with a fuse with a rating of 10 A – 16 A. IKEA
of Sweden shall not be responsible for the
damages that shall be incurred as a result
of operating the product without ensuring
ground and electrical connections made as
per local or national regulations.
• The product's power cable must be
unplugged during installation. Otherwise,
risk of electric shock and injury may occur!
• Do not plug the product to loose, broken,
dirty, greasy sockets or sockets that have
come out of their seats or sockets with a
risk of water contact.
• Place the power cord and hoses (if
available) of the product so that they shall
not cause a risk of tripping over.
• Penetration of humidity to live parts or to
the power cord may cause short circuit.
Thus, do not use the product in humid
environments or in areas where water may
splash (e.g. garage or laundry room). If the
refrigerator is wet by water, unplug it and
contact an authorized service.
• Do not connect your refrigerator to power
saving devices. These systems are harmful
for the product.
To download the full version visit www.ikea.com
5