Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
5. Wiring (Continued)
Fitting the clampers
Fitting hole
① Insert the projection
into the fitting hole
6. Preventing falling over
In order to prevent the unit from falling over, fix it
by passing strong cords or wires to the crossover
points (1 each on the right and left) of the mounting
brackets and the fitting (top), and connect them
without slack to sturdy pillars or walls.
(Use commercially available cord or wire to prevent
falling over.)
The distance between the pillar or wall and the rear
of the display must be 1 m (39.4 inches) or less.
32
(Continued)
Lift up when loosening
the clamper
② After bunching together cables such as
connection cords, pull the end to draw
them tight
Strong cords or wires
available on the market
Werbung
