Technical Description
1 Transmitter
2 Field housing (if required, commercially available)
*) Only in connection with the prescribed protection requirements for the sensor
Figure 1
1.2
Product features
•
Transmitters in four-wire technique with HART interface
•
Housing for mounting on 35 mm DIN rail or 32 mm G-rail.
•
Screw-type connector
•
Electrical isolation of all circuits
•
Output signal 0/4 ... 20 mA or 0/2 ... 10 V
•
Available with power supply units U
•
Explosion protection [ Ex ia ] or [ Ex ib ] for 7NG3242-1 for measuring process
variables in the Ex area with the appropriate device version (gas and dust Ex)
•
Temperature linear characteristic for all temperature sensors
•
User-specific characteristics
•
Automatic correction of zero point and span
•
Monitoring of the sensor and its supply cable for break and short-circuit
•
Sensor error and / or limit value can be output by an optional sensor errorlimit
value alarm (alarm relay)
•
Hardware write protection for HART communication
82
Control station
Areas of application of the transmitters in Ex and non-Ex versions
Field
230 V or U
24 V
H
H
Zone
Zone 0
SITRANS TW
A5E00054075-05