Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Care and maintenance
The seat textile cover can be machine washed at 30º C on a gentle cycle. Do not put the cover in a dryer as this can
damage the cover and the padding may separate from the fabric. Visit www.axkid.com to find videos explaining how to
remove and attach the cover.
If the textile seat cover needs replacing, ensure only original products from Axkid are used. If other products are used, the Axkid
car seat' s safety system may be compromised and could lead to severe injury in case of an accident.
Any plastic parts of the Axkid car seat can be cleaned with mild detergent and water. Do not use aggressive chemicals contain-
ing solvents or similar, as this can cause damage to the plastic and compromise the safety of the car seat.
Remove the textile cover:
•
Remove the ASIP pad (H) if attached.
•
Pull the headrest (A) to its topmost position. Loosen the harness by pressing the harness release button (E) and pull out
both shoulder straps (S) at the same time.
•
Unzip the two zippers on the underside of the headrest (A) and carefully pull the cover off from the headrest (A).
•
Lower the headrest (A) to its lowest position.
•
Unlock the harness buckle by pressing the buckle release button (C) and remove the buckle cover.
•
Unzip the zipper and open the belt clamp lid (P) and remove the plastic lid from the textile cover.
•
Open the 4 buttons on the textile cover on the backside of the car seat.
•
Unzip the two zippers at the backrest on the inside of the car seat and gently remove the textile cover from the car seat. Be
careful around the ASIP pad and other plastic covers to avoid damaging the textile. Don't pull too hard.
•
Open the shoulder pads and gently remove them from the Velcro.
Install the textile cover:
•
Reverse the steps from the instruction above to install the textile cover on the car seat again.
Note: The shoulder pads can be installed at different positions. Install them in a position suitable for your child, the shoulder pads
should be positioned on top of the shoulder and on the chest of your child. Also make sure that the rubber side of the shoulder
pad is facing your child' s chest.
Warranty
The Axkid car seat is covered by a 24-month warranty from date of purchase. Ensure you save your receipt and bring it to your
place of purchase if you have any warranty issues.
The warranty does not cover:
•
Normal wear and tear.
•
Damage due to incorrect use, neglect, or accident.
•
If repairs have been carried out by a third party.
•
All materials used have a very high UV-resistance rating. However, UV-light is very aggressive and will ultimately lead to fad-
ing of the seat cover. This is not covered by our warranty as it is considered normal wear and tear.
•
Handle the seat with care. Never carry the seat by holding in the headrest (A).
21
EN
Werbung
