Dismantling; Disposal - Maico ECA 100 ipro VZC Montage- Und Betriebsanleitung

Fault Cause, Measure
Fan does not A high-impedance voltage
switch off applies against terminal L1
or with a control switch negative
fan switch on glow lamp, parallel installed
accidentally. wires (mutual induction) or
transformers respectively
other electrical parts.
Recommendation: Connect a
X2-capacitor (220 nF/250 V)
against neutral lead.

11. Dismantling

Dismantling may only be undertaken
by an electrician.
Danger to life from electric
shock.
DANGER
Switch off mains fuse before
removing.
Danger of burning due to
contact with bimetal (K units).
Bimetal [5.3] is very hot after fan
CAUTION
is switched off. Do not touch.
Cool-down time can be up to
10 minutes
1. Unlock covers (see arrow) and remove.
2. Remove electronics cover [4] (3 latches).
3. Remove power cable.
4. Remove fan.
.
10. Fault rectification │ EN

12. Disposal

Not in domestic waste. The unit
contains in part material that can be
recycled and in part substances that
should not end up as domestic
waste.
Dispose of the unit once it has reached the
end of its working life according to the regu-
lations valid where you are.
21