Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Warning!
You must read and completely understand the Safety Considerations part of this manual before using the
instrument.
1-Safety Considerations
This manual contains instructions regarding the safe use and the proper functioning of the instrument. If not
complied with, the user could be exposed to danger and the instrument to possible damage.
1.1-International Symbols
WARNING!
CAUTION! Voltage present
Earth
Double Insulation (Class II insulation)
Fuse
Prohibited to use for the Electrical System which uses the volt
>550V
Conformity to European Standards
1.2-Terminology
The term WARNING as used in this manual de nes a condition or a procedure which could lead to a serious
injury or accident. The term CAUTION de nes a condition or action which could lead to the instrument being
rendered defective during the testing process.
1.3-Warnings
• Make sure to read and fully understand the instruction contai
• This instrument is not intrinsically safe therefore do not us
• In order to prevent re and/or electrical shock, do not use
environments.
• Prior to use, check if the instrument functions correctly. If any symptoms/symbols of malfunction or abnormalities
are indicated, do not use and inform RS components.
• Users who could be exposed to voltages in excess of the extra
competent and be aware of the requirements of GS 38 regarding the use of the instrument and the associated
leads and probes etc.
• Make sure your ngers holding the test probes are positioned
• DO NOT OPEN THE INSTRUMENT.
• If the internal fuse (protective device) operates, replace wi
again seek professional advice. DO NOT REPLACE FUSE AND TRY AGAIN.
• When carrying out the "dead tests" ensure prior to connection
has been con rmed "dead" and secured in the OFF position usi
• Battery condition is indicated by a beep. Check and replace i
• Do not test an electrical circuit or systems where the voltag
• Ensure at all times the leads are in compliance with GS 38 (a
Multifunction Installation Tester/English
age above 550V
ned within this manual prior to use.
e the instrument in hazardous environments.
the instrument in wet, damp or highly humid
low band (50V ac or 120V dc) should be
behind the safety lines of the test probes.
th a device of the same type and rating. If it operates
of the instrument leads the circuit under test
ng appropriate methods.
f necessary.
e is in excess of 550V.
s supplied) and not damaged.
1
Werbung
