Werbung
Verfügbare Sprachen
Verfügbare Sprachen
22
www.electrolux.com
indicator
that it is time to clean the filter. The
notification stays on for 30 seconds
after you deactivate the hood and the
hob. The notification does not block
the use of the hob.
WARNING!
An oversaturated filter can
pose a risk of fire.
Disassembling / reassembling
the filter
The filter and filter housing are located
right under the grid in the centre of the
hob. Remove them carefully as they
might be slippery due to accumulated
grease.
1. Remove the grid.
2. Take out the filter housing.
3. Gently push the two elements from
the outside in and fold them together.
Then take out the filter from the filter
housing.
starts blinking to signal
4. Reassemble the filtering unit after
cleaning:
a. Slide the filter elements inside
the filter housing along the built-
in runners.
b. Place the filter housing back
inside the hood cavity.
Cleaning the filter housing
Wash the filter housing manually using a
mild detergent and a soft cloth. You can
also wash it in the dishwasher.
Cleaning the filter
1. Wash the filter in warm water using a
mild cleaning agent. You can use a
soft sponge, a soft cloth, or a non-
abrasive cleaning brush to remove
food remains, if necessary. You can
also wash the filter in a dishwasher at
65-70 °C (using a program longer
than 90 min), without dishes in the
same load.
2. Dry the filter in the oven for 20-30
min at 70 °C. Place the filter on the
middle wire shelf. Make sure to use a
non-fan oven function. Alternatively,
you can leave the filter to dry
overnight at room temperature. The
filter needs to be fully dried before
reassembly.
3. Reassemble the filtering unit and put
it back inside the hood cavity.
4. If the notification
briefly to reset the counter.
The counter restarts.
is blinking, press
Werbung
