Werbung
Verfügbare Sprachen
Verfügbare Sprachen
14
www.electrolux.com
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the
cooking zone has cooled down.
5.7 Timer
Count Down Timer
Use this function to specify how long a
cooking zone should operate during a
single cooking session. You can set the
function for the hood separately. Refer to
"Hood functions".
Set the heat setting for the selected
cooking zone and then set the function.
1. Press
display.
2. Press
minutes).
3. Press
seconds. The timer begins to count
down.
To change the time: select the cooking
zone with
To deactivate the function: select the
cooking zone with
remaining time counts back to 00.
The timer finishes counting down, a
signal sounds and 00 blinks. The cooking
zone deactivates. Press any symbol to
stop the signal and blinking.
Minute Minder
You can use this function when the hob
is activated but the cooking zones do not
operate. The heat setting shows 00.
1. Press
2. Press
The timer finishes counting down, a
signal sounds and 00 blinks. Press any
symbol to stop the signal and blinking.
To deactivate the function: press
and
. The remaining time counts back
to 00.
. 00 appears on the timer
or
to set the time (00-99
to start the timer or wait 3
and press
or
.
and press
.
or
to set the time.
5.8 Power management
If multiple zones are active and the
consumed power exceeds the limitation
of the power supply, this function divides
the available power between all cooking
zones (connected to the same phase).
The hob controls heat settings to protect
the fuses of the house installation.
• Cooking zones are grouped according
to the location and number of the
phases in the hob. Each phase has a
maximum electricity loading. If the
hob reaches the limit of maximum
available power within one phase, the
power of the cooking zones will be
automatically reduced.
• The heat setting of the cooking zone
selected first is always prioritised. The
remaining power will be divided
between the previously activated
cooking zones according to the order
of selection.
• For cooking zones that have a
reduced power, the control bar blinks
and shows the maximum possible
heat settings.
• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones
. The
will continue operating with the
reduced heat setting. Change the
heat settings of the cooking zones
manually, if necessary.
• The hood extractor is always available
as an electrical load.
Refer to the illustration for possible
combinations in which power can be
distributed among the cooking zones.
Werbung
