Toro eTimeCutter eMR4275 Bedienerhandbuch Seite 54

Blade Service (continued)
5. Measure from the tip of the blade to the level surface.
6. If the difference between A and B is greater than 3 mm (1/8 inch), replace the blade.
Note:
the blade motor shaft could be bent. Contact an Authorized Service Dealer for service.
7. Repeat this procedure each blade.
Removing the Blades
Replace the blades if they hit a solid object, or if the blade is out of balance or bent.
1. Hold the blade end using a rag or thickly
padded glove.
2. Remove the blade as shown.
Maintenance: Mower-Deck Maintenance
G447261
G447260
If you replace the blade and the difference continues to exceed 3 mm (1/8 inch),
G448104
Page 5–8
Blade edge previous measured
Opposite blade edge
Blade (in position for measuring)
Level surface
Measured distance between blade
and the surface (B)
3445-793 A