Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installing the Battery Packs
Any Flex-Force Power System® battery can be used with the machine.
Install at least 3 fully charged batteries, with 4 Ah or higher, for best mowing performance; 2
or fewer batteries, or batteries with lower amperage, may only provide enough power to
drive the machine. Install more batteries and/or batteries with higher amperage to increase
machine runtime.
Use the battery packs only in temperatures that are within the appropriate range;
refer to
Specifications, page
1. Make sure that the vents on the batteries are clear of any dust and debris.
2. Lift up the battery-compartment lid.
3. Align the cavity in the battery pack with the
tongue on the machine and slide the battery
pack into the compartment until it locks into
place with an audible click.
4. Turn the key switch to the O
ensure that the LED light next to each battery
pack illuminates.
Note:
pack, refer to
5. Close the battery-compartment lid.
Note:
close completely, the batteries are not fully
installed.
Performing Daily Maintenance
Before starting the machine each day, perform the Each Use/Daily procedures listed in the
Maintenance Schedule.
3445-793A
3–6.
If a light does not illuminate for a battery
7 Troubleshooting, page
If the battery-compartment lid does not
IMPORTANT
position and
N
7–1.
Page 4–2
G445491
Operation: Before Operation
Werbung
