Toro TimeCutter ZR 4200T Bedienungsanleitung Seite 40

Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse type:
•
Main—F1 (25 A, blade-type)
•
Charge Circuit—F2 (15 A, blade-type)
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the seat to access the fuses.
4. To replace a fuse, pull out the fuse to remove
it (Figure 50).
Figure 50
1. Charge circuit (15 A)
5. Lower the seat.
ARK
g293931
2. Main (25 A)
Drive System
Maintenance
Checking the Tire Pressure
Service Interval: Every 25 hours—Check tire
pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause an uneven
cut. Check the pressure at the valve stem
Check the tires when they are cold to get the most
accurate pressure reading.
Inflate the front caster wheel tires to 206 kPa (30 psi)
or the pressure indicated on the sidewall, whichever
is lower.
Inflate the rear drive-wheel tires to 90 kPa (13 psi).
1. Valve stem
38
(Figure
Figure 51
51).
g000554