Toro TimeCutter ZR 4200T Bedienungsanleitung Seite 36

Figure 43
7. Dispose of the used oil at a recycling center.
Servicing the Spark Plug
Service Interval: Yearly—Change the spark plug(s).
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
the spark plug and a gapping tool or feeler gauge to
check and adjust the air gap. Install a new spark plug
if necessary.
Type: Champion
Air gap: 0.76 mm (0.03 inch)
Removing the Spark Plug
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
g373565
operating position. Allow the engine to cool.
3. Clean the area around the base of the plug to
keep dirt and debris out of the engine.
4. Remove the spark plug
Checking the Spark Plug
Important:
Do not clean the spark plug(s).
Always replace the spark plug(s) when it has a
black coating, worn electrodes, an oily film, or
cracks.
If you see light brown or gray on the insulator, the
engine is operating properly. A black coating on the
insulator usually means the air cleaner is dirty.
Set the gap to 0.75 mm (0.03 inch).
34
® XC92YC
(Figure 44).
Figure 44
ARK
g027478