cecotec READYWARM 4000 THERMAL CERAMIC CONNECTED Bedienungsanleitung Seite 25

3. OPERATION
Warning
For the device to be able to operate, the set temperature must always be higher than the room
one. The panel will display the room temperature. As the temperature shown on the display is
the one next to the device and not the real room one, when setting the temperature, select a
few more grades than desired ones.
Display and buttons
Fig.5
6 buttons
- Icon 1. On/Standby
- Icon 2. Increase temperature; hold down to increase rapidly. Increase time in the 24-hour
programme setting.
- Icon 3. Decrease temperature: hold down to decrease rapidly. Decrease time in the 24-hour
programme setting.
- Icon 4. Mode or programme selection.
- Icon 5. Settings/OK
- Icon 6. Open window on/off and Wi-Fi function
Quick Start
- Press the power/standby button to turn on the display, the equipment will operate in
Comfort mode.
- Press (+) or (-) to set the desired temperature.
Clock settings
Note
To start using programmes P1/P2/P3, the clock must be previously set.
- Hold down the OK button for 3 seconds to set the clock.
- To set the clock time, the hour digit (first digit) will first start blinking.
- Press +/- to set the correct hour (0-23) and the OK button to switch to the minutes
configuration.
- Press +/- to confirm minutes (0-59) and press the OK button to enter the weekday
configuration.
- Press +/- to set the day of the week from 1 to 7 and then press OK to finish the date
configuration.
READYWARM 4000 / 6000 / 8000 THERMAL CERAMIC CONNECTED
ENGLISH
25