EuroLite AKKU Multiflood IP 8x10W RGBW Wash CRMX Bedienungsanleitung Seite 33

EUROLITE IR-38 remote control
The IR remote control has the following functions:
_
+
OFF
FAV FAV FAV
1 2 3
FADE
STROBE COLOR
JUMP
FLASH
WHITE
*
Preset color
R<255>,G<121>,B <000>,W <000>
Preset color
R<110>,G<000>,B <191>,W <000>
Preset color
R<000>,G<255>,B <255>,W <000>
Preset color
R<255>,G<000>,B <255>,W <000>
Preset color
R<255>,G<255>,B <000>,W <000>
Notes:
• When actuating a button, always direct the remote control towards the sensor. There must be no obstacles
between remote control and the sensor.
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2032 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
Buttons
ON
OFF ON
Pty1
_
Pty2
+
Pty3
Pty4
CC
FAV FAV
1 2
Pty1
Pty2
Pty3
Pty4
CC
FADE
JUMP
STROBE
WHITE
COLOR
FLASH
Function
IR remote control
on/off
Dimmer intensity of the LED colors /
stepless RGBW color mixture, brightness with
+ and -
Preset colors*,
brightness with + and -
F
avorite color setting - press one of the 3 buttons
FAV
for 3 seconds to save your own color mix.
3
Internal program Pty 1,
Switching colors, speed with + and -
Internal program Pty 2,
Switching colors, speed with + and -
Internal program Pty 3,
Switching colors, speed with + and -
Internal program Pty 4,
Switching colors, speed with + and -
Switching through preset colors 01-15,
brightness with + and -.
Fade/Jump
Switching internal programs
Pty1-Pty4
Strobe effect only for white,
speed with + and -
A second press ends the strobe effect.
Strobe effect 12 colors,
speed with + and -
A second press ends the strobe effect.
33/40 00151627, Version 1.0