EuroLite AKKU Multiflood IP 8x10W RGBW Wash CRMX Bedienungsanleitung Seite 29

Charging the rechargeable battery
Prior to operating the device off mains for the first time, the rechargeable battery must be fully charged. You
can charge the product using the power cable.
1
The operating time of the battery depends on the operating mode and the ambient temperature (max. 9
hours). After the operation, switch the device off.
2
For charging the battery, connect the device to a power outlet via the power cable provided. Charging
time is 4.5 hours. The device may be operated during the charging procedure.
3
The device features a protective circuit for charging which prevents overload of the rechargeable
battery. However, disconnect the device from the mains after charging. Otherwise there will be a low
current consumption even if the device is switched off.
4
The device will heat up during charging; this is normal.
5
To prevent damage to the battery by deep discharge, recharge a completely discharged battery as soon
as possible. Do not store the unit with the battery completely discharged and regularly recharge the
battery in case of long storage.
Maximum battery run time
9 hours
Battery status
The battery charge status is indicated on the display. The display shows the battery charge status in %. If the
display shows 100%, the battery is fully charged. If the display shows 20% or less, the battery will be going
flat soon and must be charged. In this state, the device can be operated for a few minutes. The estimated
remaining runtime, depending on the selected operating and battery mode, is shown on the display. Then an
emergency switch-off deactivates the device to protect it from total discharge. Please note, that it may take a
few seconds after changing the device settings for the remaining runtime to be recalculated and displayed.
OPERATION
After you switch on the device with the power button the device starts running. The display indicates the last
operating mode. The operating modes can be selected by means of the display and the control buttons. All
settings remain stored even if the device is disconnected from the mains. The device can be operated in
stand-alone mode via the control board and controlled via remote control (EUROLITE IR-38), DMX signal
and W-DMX signal.
Stand-alone mode
In the stand-alone mode, you can do without a controller. Disconnect the device from the controller and de-
activate CRMX and call up the desired setting. Please refer to the instructions under Control Board.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1. Configure all slave units before connecting the master unit: Press the MENU button so many times until
"MASTSLAV" is indicated on the display. Confirm with the ENTER button. Set "Slave" on all slave units
with the UP and DOWN buttons. Confirm with the ENTER button. Set "Master" on the master unit using
the UP and DOWN buttons. Confirm with the ENTER button.
2. Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3. Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.
Recharge time
4.5 hours
29/40 00151627, Version 1.0