EuroLite AKKU Multiflood IP 8x10W RGBW Wash CRMX Bedienungsanleitung Seite 27

INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must
never be fixed swinging freely in the room.
1 The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2 Block access below the work area and work
from a stable platform when installing the
device.
3 Use rigging hardware that is compatible
with the structure and capable of bearing
the weight of the device. Please refer to the
"Accessories" section for a list of suitable
rigging hardware. Screw a clamp via a M10
screw and self-locking nut onto the Omega
bracket. Insert the two quick-lock fasteners
of the Omega bracket into the respective
holes on the bottom of the device. Tighten
the quick-lock fasteners fully clockwise.
4 Secure the device with a safety bond or
other secondary
secondary safety attachment must be
sufficiently dimensioned in accordance with
the latest industrial safety regulations and
constructed in a way that no part of the
installation can fall down if the main
attachment fails. Use the hole in the bracket
for fixation of the safety bond. Fasten the
safety bond in such a way that, in the event
of a fall, the maximum drop distance of the
device will not exceed 20 cm.
5 To align the device, release the fixation
levers at the mounting bracket, adjust the
desired inclination angle and tighten the
fixation levers.
6 After installation, the device requires inspections periodically to prevent the possibility of corrosion,
deformation and looseness.
Changing the beam angle
With the delivery of the device you will receive a frost filter, with which the beam angle can be changed from
10° to approx. 25°. If present, please remove the protective foil of the frost filter when using it for the first
time. If you want to change the beam angle of the device, attach the filter using the folding latch on the front
of the device. Make sure that the frost filter is firmly attached to avoid accidental loosening of the frost filter.
attachment. This
(1) Safety bond
(2) Clamp
(3) Omega bracket
(4) Quick-lock fastener
1
27/40
2
3
4
00151627, Version 1.0