Werbung
ENGLISH
Installer instructions
For some models the installer can change the factory settings:
VK
No configuration tasks for the installer
VK N
Factory settings
- switch-off delay (dip switch): 6 min
- switch-on delay (dip switch): 45 seconds
- automatic switch-on cycle: OFF = 0 H
- 2 speeds: position A of the jumper (fig.17 A)
Possible settings
- Jumper setting (fig 17). The motor has two operating speeds: V1 and V2. By appropriately setting the jumpers
as described in the following table A it is possible to determine which will be the maximum and minimum
speed between V1 and V2. The timer will always act on V1 (Position A: fig.17 A, Position B: fig. 17 B).
17
17
66
A
B
Dip
Jumper
Switch
100 VK N
Dip
Jumper
Switch
HCS
Sensor
100 VK NF
Werbung
