Werbung
ENGLISH
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this appliance.
• Do not expose this appliance to the elements (rain, sun, etc.).
• Regularly inspect the appliance for visible defects. If any faults are found, do not operate the appliance but
contact a Vortice authorised Technical Support Centre immediately.
• If the appliance malfunctions and/or develops a fault, contact a Vortice authorised Technical Support
Centre immediately. Ensure that only genuine original Vortice spares are used for any repairs.
• Should the appliance be dropped or suffer a heavy blow, have it checked immediately by a Vortice
Authorised Technical Support Centre.
• The electrical system to which the appliance is connected must conform to applicable standards.
• The appliance is double insulated and therefore does not need to be earthed.
• Connect the appliance to the electrical power supply/socket only if the rated power of the supply is
sufficient to match the maximum rated power of the appliance. If not, contact a professional electrician
without delay.
• Switch off the system's main switch:
a) if the appliance does not function correctly;
b) before cleaning the outside of the appliance;
c) if you decide not to use the appliance for any length of time.
• The room must have an adequate source of replacement air for this appliance to function effectively. In the
event that other non-sealed combustion based appliances (such as water heaters, gas stoves, etc.) are
installed in the same room, check that air replacement is sufficient for all appliances to work effectively
together.
• The appliance must either exhaust directly to the outside or into a short duct (max 400 mm to ensure the
certified technical data). Efficiency losses will occur if the appliance is installed in ducting subject to any
appreciable level of back pressure.
• Specifications for the power supply must correspond
to the electrical data on ID plate A (Fig.1)
• The appliance cannot be used to control water heater
switches, heaters, etc.; neither must it expel air into
the hot air ducts of such appliances.
• The air or fumes to be extracted from the room must
be clean (i.e. free of grease, soot, chemical and
corrosive agents, and explosive or flammable
mixtures) and must not exceed a temperature of 50°C
(122°F).
• Keep the appliance's intake and outlet grilles free to
ensure an optimum flow of air.
• Model 100 VK NF: do not cover or obstruct the grille
of the humidity sensor.
1
A
57
Werbung
