Werbung
ENGLISH
The appliance must be installed by a professionally qualified
•
electrician.
A multi-pole switch must be used to install the appliance. The
•
contact opening gap must be no less than 3 mm.
Items supplied
The fan unit is enclosed in a plastic cylinder incorporated in the motor carrier, which can be entirely
accommodated in the destination pipe and whose short length makes it perfectly compatible with installation
near elbow bends (90°), typical of pipe fittings.
The main parts of the appliance are:
• Motor carrier and front panel, made of ABS thermoplastic, impact resistant and anti-UV resin;
• Centrifugal rotor made of PP resin, designed for high performance, low power consumption and low noise
emissions;
• Motor with shielded poles, equipped with ball bearings and fitted with a thermal fuse;
• PCB, different depending on the model.
Installation
2
58
3
100 mm
Werbung
