Echo DLM-310/46SP Benutzerhandbuch Seite 11

EN
If the blade does not stop when the handle switch
is released, remove the safety key or battery to stop
the power supply to product. Have your dealer repair
product before using product again.
Wait until the blade fully stops before you start the
machine again. Do not quickly turn the machine off
and on or it will damage the machine.
Always remove the safety key and battery pack after
you complete the work.
9.3 OPERATE THE SELF-PROPEL
SYSTEM
Figure 9.
1. Start the machine.
2. While you hold the bail switch, push the self-propel
lever in the direction of the handle bar.
3. Hold the bail switch and the self-propel lever at the
same time with your right hand.
4. Adjust the speed control button with your left hand.
• Push the speed control button in the direction of
the Rabbit Symbol to increase the speed.
• Pull the speed control button in the direction of
the Turtle Symbol to decrease the speed.
5. Release the self-propel lever to stop the self-propel
system.
9.4 EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge flap and hold it.
5. Hold the grass catcher by its handle and unhook it
from the door rod.
6. Close the rear discharge flap.
7. Empty the grass catcher.
9.5 OPERATE ON SLOPES
Do not mow on the slopes with incline more than 15°.
If you are not comfortable, do not mow on a slope.
English Original Instructions
WARNING
WARNING
WARNING
WARNING
Please keep a low self-propelled speed when you
mow on a slope.
• Do not go up and down on a slope, mow across the
face of the slope. Be careful when you change the
direction on a slope.
• Monitor the holes, ruts, rocks, and other hidden
objects that can cause you to fall. Remove all
obstacles such as rocks and tree limbs.
• Make sure that your footing is stable. If you are out
of balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or
embankments.
9.6 OPERATION TIPS
• Do not try to override the operation of the start
button or bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning
parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick
grass.
• Clean the bottom of the mower deck after each
use. Remove grass clippings, leaves, dirt, and other
debris.
10 MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
10.1 GENERAL MAINTENANCE
• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use
water.
10
WARNING
CAUTION
CAUTION
WARNING