Husqvarna Knut 39 Bedienungsanweisung Seite 9

Status indication LEDs
LEDs
Green light is on. (A)
Yellow light is on. (B)
Red light is on. (C)
To operate the product
1. Make sure that the rebars are set up correctly. Make
sure that the rebars have the correct dimension.
Applicable rebar dimensions on page 8 .
Refer to
2. Make sure that there are no dirt or wire parts in the
wire inlet or in the coil cover.
3. Hold the product with 1 hand and the rebar in 1
hand.
4. Set the ON/OFF switch to ON, refer to
product on page 8 .
5. Hold the product in a 45 degree angle with the
center of the wire winding head against the rebars.
Refer to the illustrations.
1721 - 001 - 13.03.2023
A
B
C
Status indication
The product is on.
The product cannot start.
Troubleshooting
Refer to
on page 12 .
The battery is almost
To charge
empty. Refer to
the battery on page 7 .
To start the
a) For parallel rebars:
45°
b) For crossed rebars:
6. Push the wire winding head tightly against the rebars
and make a small counterclockwise movement. This
locks the wire winding head against the rebars and
gives a better knot result.
Note:
If the rebar dimension is smaller than the
wire winding head, hold the wire winding head tightly
against 1 rebar to get a stable position.
Note:
Do not move the product during the
operation.
45°
9