Husqvarna Knut 39 Bedienungsanweisung Seite 11

To stop the product
• Push the ON/OFF switch to OFF (B), to stop the
product. The power is OFF.
WARNING:
switch to OFF when you do not operate
the product to prevent accidental start.
To remove the battery from the product
• Push the release button and pull the battery out.
To replace the wire
CAUTION:
Technical data on page 15 .
refer to
1721 - 001 - 13.03.2023
A
B
Always set the ON/OFF
Only use the correct wire,
1. Set the ON/OFF switch to ON and pull the coil cover
to open it.
2. Make sure that there is no corrosion, dirt or damage
on the wire.
3. Release the remaining wire from the wire inlet.
4. Lift the wire coil out of the wire housing.
5. Put the new wire coil in the wire housing. Make sure
that it has correct position and that the end of the
wire is straight and clean.
11