Husqvarna Knut 39 Bedienungsanweisung Seite 10

7. Push the power trigger.
8. When the product stops automatically, release the
power trigger.
9. Do a check of the wire knot:
a) Make sure that the wire knot keeps the rebars
tightly together.
b) Make sure that the wire knot has the shape of a
flat spiral, with 3 turns.
c) Make sure that the end of the wire does not point
up.
10. If the check shows that the wire knot is not correct,
do these steps:
a) Make sure that the product is operated as given
in this operator's manual.
b) Make a new wire knot on top of the first wire knot
to increase the strength.
10
11. Make each wire knot perpendicular to the adjacent
wire knot as shown in the illustration.
12. If more strength is necessary for crossed rebars,
make perpendicular wire knots on top of the first wire
knots.
1721 - 001 - 13.03.2023