Husqvarna Knut 39 Bedienungsanweisung Seite 12

6. Push the wire into the wire inlet by hand (A) and
push the power trigger (B). The wire moves forward.
Continue to push the power trigger for 2 seconds
after the wire starts to move automatically.
A
B
Daily maintenance
• Clean the wire winding head with compressed oil
free air each 2500 knots or at the end of the work
day.
Problem
The product does not start.
12
7. Make sure that the wire coil and wire is in correct
8. Make sure that the coil cover is closed before
Maintenance
Troubleshooting
Cause
The battery is not charged.
There is an electrical fault.
The ON/OFF switch is OFF.
The temperature of the battery is too
high, refer to Technical data on page
15 .
The product is broken.
position in the wire housing.
operation.
Solution
Set the ON/OFF switch to OFF
and charge the battery. Refer to
charge the battery on page 7 .
Remove the battery and install it
again. Refer to
from the product on page 11 and To
install the battery on the product on
page 7 .
Set the ON/OFF switch to ON.
Let the battery become cool.
Speak to your Husqvarna service
agent.
To
To remove the battery
1721 - 001 - 13.03.2023