Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating the Dishwasher
3.2 Dish washing operation
Program selection and operation
• Draw out the lower and upper basket, load the dishes as discri-
bed before and push them in again completely.
It is recommended to load the lower basket fi rst.
• Fill the detergent dispenser according to your current needs.
• Make sure that the plug is inserted into the socket and
the water supply is turned on to full pressure.
• Open the door if necessary and press the On/Off button
to switch on the machine.
• Select the desired washing program by pressing the
program button
program indicator lights up.
• Close the door. The dishwasher will start its cycle.
Changing the program in the middle of the cycle
A program can only be changed if it has been running for a
short time, otherwise the detergent may have already been
released and the dishwasher may have already drained the
wash water.
If this is the case, the dishwasher needs to be reset
and the detergent dispenser must be refi lled.
To reset the dishwasher, follow the instructions below:
• Open the door a little to stop the washing process.
When the spray arms stop rotating, you can open the door
completely.
• Press the Program button
The dishwasher will enter standby mode.
• Select the desired washing program as described before.
• Close the appliance door. The dishwasher will start its cycle.
34
repeatedly until the corresponding
for more than 3 seconds.
Werbung
