Kesser K-HL-01MF Bedienungsanleitung Seite 12

8. To replace step 6. You can also press the button once or twice to get the heat
directly. Pressing once is set to low heat and pressing twice to high heat. On the third
press of this button, it comes back only with cool airflow mode.
9. By pressing , you can set the timer from 0 to 8 hours.
10. By pressing , you can adjust the heating with or without vibration.
11. If you want to turn off the heating, you
icon lights up,
and at the same time the entire heater will turn off, and only the fan will blow after 30
seconds. The heating only turns off when the room temperature is displayed.
Oscillation
This device also has a vibration function. To turn on the function, press the button . To stop it,
press the swing switch again.
TIMER FUNCTION
This feature works in any mode. With the timer function, you can set the operating time from 1
hour to 8 hours. Pressing the timer button extends the operating time by 1 hour each time you
press the button When you set the timer, the hours are counted down by 1 hour in 1 hour. The
display shows the remaining operating time until the heater turns off on its own. By pressing
the timer button again, the heater is put back into continuous operation after 8 hours.
THERMOSTATANLEITUNG
1. To set the temperature, press the "+" button to increase the desired temperature and "-" to
decrease the desired temperature
2. If the air temperature is 3 degrees above the set temperature, the heating is switched off
3. If the air temperature drops 1 degree below the set temperature, the device will be turned
on again.
4. Temperature can be set from 15 degrees to 35 degrees.
Remote control
1. Remote control, please use lithium battery CR2025 3V.
2. The power button of the remote control is marked as such.
3. All functions performed with the remote control are identical to the manual controls.
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
12
can press, this time the "Wind blade"
www.eshopping.de