Kesser K-HL-01MF Bedienungsanleitung Seite 11

• This unit is not intended for use in bathrooms, laundries or similar places exposed to water,
moisture or humidity.
• Always work on a flat, horizontal surface.
• Turn off the device and use the handles (if any) to change the position.
• Do not use the cable rolled up as this can cause heat build-up and pose a hazard.
• The use of an extension cable for this device is not recommended.
• Do not unplug the power plug on the cable from the socket, but touch it on the plug.
• Always unplug when not using the device.
• Do not allow the cable to come into contact with heated surfaces during operation.
• Do not lay the cable under carpets, do not throw carpets or runners, etc. Do not lay the
cable near areas that are likely to be stumbled upon.
• Do not twist, bend or wrap the cable around the device as this can weaken and split the
insulation. Always make sure that the cable has been completely removed from the cable
storage area before use.
• Do not store the device in a box or in an enclosed space until it has cooled down
sufficiently.
• This device is not intended for use by persons (including children) with limited physical,
sensory or mental abilities or lack of experience and knowledge, unless they have been
supervised or instructed in the use of the device by a person responsible for their safety.
• Infants should be supervised to ensure they are not playing with the device.
• The device must not be placed directly under a power outlet.
• Do not use this device with a programmer, timer or other device that automatically turns on
the heater, as there is a risk of fire if the device is covered or incorrectly positioned.
• If the power cord is damaged, it must be replaced by a qualified electrician to avoid
hazard.
• Do not use this device outdoors or on wet surfaces. Do not spill liquid on the device.
• In order to avoid a risk of accidental resetting of the thermal switch, this device must not be
connected via an external switchgear, such as a timer, or to a circuit that is regularly
switched on and off by the network operator.
Overview
Service
1. Before plugging the plug into a power outlet, make sure that the power supply near
you matches the one indicated on the device's nameplate.
2. Carefully remove the heater from the plastic bag and cardboard box.
3. Place the heater on a fixed flat surface.
4. Set the main switch to Off. Plug the power plug into a 220-240V~AC outlet. Switch the
main switch to "On".
5. Turn on the heater by pressing the main switch ON/OFF on the back of the heater. The
device displays the current room temperature.
6. By pressing the button, the device blows out the cold air.
7. When you press the button
temperature that you can set up to 35 °C). If the set temperature is higher than the
room temperature, the device sets the temperature. Start a heating stage, and at
that time start a heating stage will light up, and at that time one of the icons will light
up . If you continue to press on
higher. The device starts a total of two cooking stages. At this point, the
light up.
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
11
, set the appropriate temperature (the highest
, the set temperature will be even
www.eshopping.de
icons