Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Installation
To install the dishwasher, follow the instructions below
according to the chapter order.
6.1 Water connection
Attention!
!
To avoid damage and malfunctions, ,
follow the following notes and instructions:
• Pipe installations and changes to the water supply must be
carried out by a certifi ed installation specialist
• If the water connection pipes are new or have not been
used for a long period of time, let the water run and make
sure that it is clear and free of impurities.
• Do not reuse old or used hose sets for installation.
• A hose that attaches to a sink spray can burst if it is instal-
led on the same water line as the dishwasher. If your sink
has one, it is recommended that the hose be disconnected
and the hole plugged.
Cold water connection
• Pull The safety supply hoses completely out from storage com-
partment located at the rear of the dishwasher.
• Tighten the screws of the safety supply hose to the cold water
faucet with thread 3/4inch.
Make sure that it is fi rmly seated and tightly closed.
• Turn the water fully on before starting the dishwasher.
Disconnection of the water supply
• Turn off the water supply.
• Unscrew the safety supply hose from the water connection.
Installation
49
Werbung
