Husqvarna S 138i Bedienungsanweisung Seite 13

Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To assemble the handle
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product. (Fig. 22)
3. Set the handle height in one of the 2 available
positions.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To set the work depth
WARNING:
depth when you operate the product.
1. Push and turn the adjustment knob for the work
depth counterclockwise to increase the work depth.
937 - 008 - 13.11.2023
Assembly
Before you assemble the
To prevent accidental start
Operation
Before you operate the
Do not adjust the work
4. Move the knobs up in the direction of the handle until
they stop and you hear a click. (Fig. 23)
5. Tighten the knobs fully.
To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag. (Fig. 24)
2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
3. Attach the grass bag to the grass catcher frame with
the clips. (Fig. 25)
4. Lift the rear cover.
5. Move the grass catcher into the correct position.
(Fig. 26)
6. Attach the grass catcher to the top edge of the
chassis. Make sure that the rear cover seals against
the grass catcher to prevent leakage. (Fig. 27)
2. Push and turn the adjustment knob for the work
depth clockwise to decrease the work depth. (Fig.
28)
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Operation of the bat-
tery
Charging of the bat-
tery
Battery status
The display shows the remaining battery capacity and
if there are problems with the battery. Push the battery
indicator button to get information of the state of charge
of the battery. The warning symbol on the battery is on
when an error has occurred. Refer to
16 .
(Fig. 29)
Before you use the battery,
Ambient temperature
5 °C - 40 °C
5 °C - 40 °C
Battery on page
13