Setting The Floating State With Load - probst UZ-BV Betriebsanleitung

Operation

6.1.2 Setting the floating state with load

Adjust the adjusting screw (2) to set the hovering state with load - be
careful not to confuse this with the hovering state without load.
•
Twisting clockwise ➔ Floating state is reduced
•
Twisting counterclockwise ➔ Floating state increases
The operating lever may be left in the "suction/lift" position for a maximum of 90 seconds, as
otherwise the fan may be damaged and fail (warranty void!) and energy is wasted
unnecessarily.
Suspended state with load should not be in the highest lifting unit position, as otherwise the
fan may be damaged and fail when the load is sucked in (warranty void!) and energy is wasted
unnecessarily.
•
Carefully transport the load/curb to its
destination and set it down in the desired
position by slowly pressing the control lever
(1) downwards. The lifting unit is released and
the operating unit lowers with the load.
•
Do not press the control lever down abruptly
as far as it will go while holding the operating
handle (3). Otherwise the load may drop
suddenly as the vacuum is completely
released.
•
Set down the load (kerb), tilt the operating unit
slightly and remove it from the load/curb.
For further details, see the enclosed operating instructions for the control unit/lifting unit.
Image A
52300031
Image B
14 / 18
Image C
GB