Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
3. 2. USING THE LIGHTING WITH A STANDARD RTS CONTROL POINT
Briefly press the Up button: the light comes on.
1)
Briefly press the Down button: the light goes out.
2)
Press and hold the Up button: the light intensity increases.
3)
Press and hold the Down button: the light intensity
4)
decreases.
Briefly press the My button: the light comes on in the pre-set
5)
favourite position.
3. 3. USING THE LIGHTING WITH AN RTS VARIATION CONTROL POINT
Briefly press the Up button: the light comes on.
1)
Briefly press the Down button: the light goes out.
2)
Use the dimmer switch to increase or decrease the light
3)
intensity.
Briefly press the My button: the light comes on in the pre-set
4)
favourite position.
3. 4. ADDING AND DELETING THE FAVOURITE POSITION
A partly-open position, referred to as the "favourite position (my)", other than the upper and
lower positions can be programmed in or deleted from the drive, just as a light intensity can be
programmed or deleted as a favourite lighting position.
Place the motorised product or adjust the light intensity in
1)
the desired favourite position (my).
Press the "My" button until the motorised product makes
2)
an up and down movement or until the light comes on then
goes out: the new favourite (my) position is programmed
and the previous favourite (my) position is deleted.
3. 5. USING SENSORS
3. 5. 1. Operation of the sensors
Protection against wind (requires the wind sensor):
Depending on the position of switch 5, the slats open or close
in the event of wind.
Protection against rain (1) (requires the wired rain sensor)
In the event of rain, the slats close completely.
if a radio rain sensor is used, refer to the sensor instructions.
24
©
Copyright
2019 - 2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
CONTROL UNIT P.TILT RTS M+L
1) 1)
2)
2)
3) 3)
4) 4)
5)
5)
1) 1)
2)
2)
3)
)
)
)
)
)
)
4) 4)
1)
1)
2) 2)
Werbung
