Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONTROL UNIT P.TILT RTS M+L
2. 5. 4. Adding or deleting a control point from another control point
RTS control point 1: already programmed on the outputs
concerned and will not be deleted.
RTS control point 2: to be programmed on or deleted from the
same outputs as transmitter 1.
Press the PROG button on the back of RTS control point 1 for
1)
more than 2 seconds until the motorised product makes an
up and down movement on the output concerned.
Briefly press the PROG button on the back of RTS control
2)
point 2 until the motorised product makes an up and down
movement on the output concerned.
The procedure to program or delete an RTS sensor is the
same.
2. 6. TIPS AND ADVICE FOR INSTALLATION
2. 6. 1. Questions about the CONTROL UNIT P.TILT RTS M+L?
The motorised
product does not
work.
3. USE AND MAINTENANCE
This receiver is maintenance-free.
3. 1. USING THE DRIVE WITH AN RTS CONTROL POINT
Press the Up button: the motorised product opens.
1)
Press the Down button: the motorised product closes.
2)
Press the My button: the motorised product stops or moves
3)
to the favourite position.
©
Copyright
2019 - 2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
The wiring is incorrect.
An incorrect cable has been used.
The control point is not compatible. Check for compatibility and replace the
1)
1)
PROG.
PROG.
1 2
4 3
2) 2)
PROG.
PROG.
Check the wiring and modify it if necessary.
Check the cable used
control point if necessary.
1) 1)
3)
3)
EN
> 2 s.
> 2 s.
2)
2)
23
Werbung
