SOMFY P.TILT RTS M+L Anleitung Seite 22

EN
2. 5. COMMISSIONING
2. 5. 1. Automatic end limit settings
The drive's end limits must match the pergola's end limits.
Press the PROG button on the circuit board for more than
1)
2 seconds until the S1 and S2 LEDs flash, then release (the
pergola makes an up and down movement).
Select output 1 by briefly pressing the PROG button; the
2)
LED corresponding to the selected output flashes.
Select the desired channel on the RTS control point.
3)
Press "Up" and "Down" simultaneously: the pergola makes
4)
an up and down movement.
Press the "Up" button to check the direction of rotation:
5)
If the motorised product opens, the direction of rotation
•
is correct.
If the motorised product closes, the direction of rotation
•
is incorrect. Press the "My" button until the motorised
product moves up and down: the direction of rotation has
been modified.
Press the "Up" button to check the direction of rotation.
6)
Press "Up" and "Down" at the same time.
7)
Do not interrupt the movement: the drive will search for its
upper end limit and lower end limit automatically.
Position the pergola in the desired position for ice / snow
8)
(press and hold down the "Up" or "Down" button).
Confirm the settings by pressing "My" for more than
9)
2 seconds (sends the information to the desired output).
Briefly press the PROG button on the back of the RTS
10)
control point until the selected output responds. The end
limit positions have been programmed.
2. 5. 2. Programming the RTS control point on the DEL
output
Press the PROG button on the circuit board for more than
1)
2 seconds until the S1 and S2 LEDs flash, then release (the
pergola makes an up and down movement).
Select output 2 by briefly pressing the PROG button; the LED
2)
corresponding to the selected output flashes.
Briefly press the PROG button on the back of the RTS control
3)
point until the selected output responds.
2. 5. 3. Restoring the original configuration
Clearing the memory completely:
Press the PROG button on the circuit board for more than
7 seconds until all the indicator lights on the circuit board light up.
22
©
Copyright 2019 - 2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
CONTROL UNIT P.TILT RTS M+L
1) 1) 2) 2)
> 2 s. > 2 s.
3) 3) 4) 4)
5) 5)
The direction of The direction of
rotation is correct rotation is correct
6) 6) 7) 7)
8) 8) 9) 9)
10) 10)
PROG. PROG.
1) 1) 2) 2)
> 2 s. > 2 s.
3) 3)
PROG. PROG.
> 7 s. > 7 s.
< 0.5 s. < 0.5 s.
> 2 s. > 2 s.
< 0.5 s. < 0.5 s.
- +
OUTPUT Vdc
POWER SUPPLY
- + - + - + - S2 +
S1
OUTPUT Vdc OUTPUT Vdc