Benelli leoncino 2018 Bedienungsanleitung Seite 124

Adjusting the headlight beams
The headlight beam adjusting screw is
used to raise or lower the height of the
headlight beams. It may be necessary to
adjust the headlight beams to increase
visibility and help prevent blinding onco-
ming drivers when carrying more or less
load than usual.
Obey local laws and regulations when
adjusting the headlights.
To raise the headlight beams, turn the
screw in direction (A).
To lower the headlight beams, turn the
screw in direction (B).
A
B
Adjusting the shock absorber
assembly
Adjustment of the hydraulic brake
action in extension
It is possible to adjust the hydraulic brake
device using the adjustment screw.
Turn it in direction "2" to increase the bra-
ke action; turn it in direction "3" to reduce
it.
3 1
2 1
1. Adjusting knob.
2. Increase braking action.
3. Decrease braking action.
3 - 15
Instrument and control functions
NOTICE
To avoid damaging the mechanism, do
not try turning over the maximum or
minimum setting.
Always have the shock absorber adju-
sted by a Benelli assistance centre.
WARNING
Read and understand the following in-
formation before handling the shock
absorber assembly.
• Do not tamper with or attempt to
1 1
open the cylinder assembly.
• Do not subject the shock absor-
ber assembly to an open flame or
other high heat source. This may
cause the unit to explode due to
excessive gas pressure.
• Do not deform or damage the
cylinder in any way. Cylinder da-
mage will result in poor damping
performance.
• Do not dispose of a damaged or
worn-out shock absorber assem-
bly yourself. Take the shock absor-
ber assembly to a Benelli dealer
for any service.
EN
3