Benelli leoncino 2018 Bedienungsanleitung Seite 117

Instrument and control functions
Electric ignition button
Press this button to start the engine with
the starter device.
ABS button
Do not try to adjust settings of ABS while
the motorcycle running. The ABS settings
EN
are not enabled when the vehicle speed is
above 5 km/h.
3
Disabling ABS
Make sure the motorcycle is stationary
and in neutral. Keep the ABS button pres-
sed for 3-5 seconds, the light will switch
from steady to flashing for about 1.30 se-
conds (short flashing).
At this stage, the ABS system will be not
active and the braking system will con-
tinue working as a normal system not
equipped with ABS.
ABS
Enabling ABS:
Make sure the motorcycle is stationary
and in neutral. Keep the ABS button pres-
sed for 3-5 seconds, the light will switch
from steady to flashing for about 1.30
seconds (short flashing). Another way for
enabling the ABS system is to switch off
and then on again.
ABS
A: the procedure will be ignored by the
system if the ABS button was pressed for a
time ranging from 5 and 30 seconds.
The ABS will keep the current settings.
~
~
~
ABS
3 - 8
B: The ABS will be active again from any
other previous setting when the button is
pressed for a time longer than 30 secs.
ABS