Protection Function
Over-Temperature Protection
To avoid overheating and deteriorating the flash head, the inner over-
•
temperature protection function will be activated. When the over-temperature
protection is started, is shown on the VA display.
When the recycle time is over 10 seconds in over-temperature protection, please
•
allow a rest time of at least 10 minutes and the flash will then return to normal.
Other Protections
The system provides real-time protection to secure the device and your safety.
•
The following lists prompts for your reference:
Prompts on
LCD Panel
E1
E2
E3
E9
Technical Data
Model
Wireless Receiver Unit Mode
Flash Mode
Compatible Cameras under Radios
Transmission (as Receiver unit)
Meaning
A failure occurs on the recycling system so that the flash cannot fire.
Please restart the flash unit. If the problem still exists, please send
this product to a maintenance centre.
The system gets excessive heat. Please allow a rest time of 10
minutes.
The voltage on two outlets of the flash tube is too high. Please send
this product to a maintenance centre.
There are some errors occurred during the upgrading process.
Please using the correct firmware upgrade method.
AD100Pro
Radio transmission mode (compatible
with Nikon & Canon & Sonya & Fujifilm &
Olympus & Panasonic & Pentax)
Wireless off
Receiver unit of radio transmission
M/Multi
TTL/M/Multi
Nikon cameras (X1T-N, X2T-N, XProN as
master unit.
Canon EOS cameras (X1T-C, X2T-C, XProC
as master unit)
Sony cameras (X1T-S, X2T-S, XProS as
master unit)
20