Lupine Wilma Bedienungsanleitung Seite 24

7
Product care and storage
Plug contacts:
Normally the plug contacts are maintenance free. However, if you use your Wilma light in humid, salt-
air, environments, it's advisable to apply a thin layer of
often to prevent oxidation. Do NOT use terminal grease or contact spray.
Transport:
Important: Always keep the battery separate from the Wilma light,
amount of power used by the electronics will discharge the battery, and the lamp may switch on
accidently. Important! Moreover, the consequent uncontrolled heat buildup could cause a fire or
melt the adjacent plastic material. Could cause fire or death!
Storage:
During lengthy periods of non-use, fully charge the battery and store it in a cool, dry place, basement
or the like. The battery can be kept plugged into the charger if desired. For further information con-
cerning battery care, consult the charger manual.
Opening the light housing:
Open the light housing's front screw-on cover. Grasp the rear section of the lamp with one hand while
rotating the front section of the cover to the left (counterclockwise) with the other hand. Once you
have removed the cover, you will see the 4-array lens. Do not touch it.
Closing the lamp housing:
Check to ensure that the O-ring on the rear section of the housing is correctly positioned.
The housing will only be waterproof if its O-ring is intact. After completing this inspection, carefully
screw down the housing cover. Important note: if the thread runs smooth, the cap is in the right
position. Otherwise please stop and screw back the cover and try again, otherwise you might
damage the thread.
4 6 Wilma
Lupine Dutch Grease to the contacts every so
because otherwise the small
Problem Cause
The light does not come on  Extremely discharged battery.
and the power LEDs do not
flash when the battery is
plugged into the lamp.
Battery not plugged into the

light or not plugged in
properly.
With the battery plugged in,  Faulty LED unit.
the power LEDs do not come
on, but the PCS LEDs flash.
The Power LEDs do not stay on  Discharged battery.
for as long as they should.  Old battery.
 Very low ambient
temperature.
Faulty charger.

Unsuitable battery.

Battery cannot be charged:  The battery's internal elec-
Charger does not respond when tronics blocked further
a battery is connected to discharge by shutting down.
it and does not begin charging. It will take the connected
Charger a few minutes
to initialize and begin
charging.
Troubleshooting
Solution
 Charge the battery. Before
doing so be SURE to read
the "Battery cannot be
charged" section below.
Check all plug contacts.

 Replace the LED unit.
 Charge battery.
 Replace battery.
 Keep battery warm.
Replace charger.

Use original Lupine battery.

 Leave the battery connected
to the charger and wait.
This process can take up to
an hour.
Wilma
8
47