Lupine Wilma Bedienungsanleitung Seite 15

2
Mounting
Uni Fit bracket:
Mounting the light on bicycle handlebars and
similarly shaped objects, or on Lupine bicycle
helmet brackets or headbands, is quick and
easy thanks to the flexible rubber O-ring.
For a demonstration of how to mount the light
on handlebars, see the video on our Website
(click "Support").
Lateral adjustment:
To adjust the light for freeride or downhill
handlebars, you can rotate the bracket on
the lamp housing 4 degrees to either side.
To do this, loosen the screw on the bracket.
28 Wilma
Use the included larger O-ring for oversized
handlebars.
Note: The product is supplied with the
O-ring for standard handlebars installed on
the bracket. To attach the light to oversized
handlebars, unscrew the bracket and repla-
ce the O-ring with the larger one.
4 ° 4 °
Helmet bracket:
The Lupine helmet bracket can be attached to virtually
any helmet that has ventilation slits. The bracket is easy
to mount. For further information, see the text and
pictures on the pages that follow.
Helpful hints: Normally the two straps are too long. However, only shorten them after
mounting and removing the bracket once, because once you've snipped off the extra length,
you can't put it back on again.
Pull both straps through the best situated ventilation slits.
1
Try out various options until you find the optimal position.
Helpful hints: Since virtually all ventilation slits are raked
forward, its best to mount the bracket as far as possible
under the edge of the helmet, to prevent the bracket from
slipping.
slits as shown in the picture. When the straps are new they
are stiff and therefore somewhat difficult to pull through the
slits, which is normal. However, with use the straps will
soften and become easier to use.
Make the straps as tight as possible by pulling hard on
them, and in such a way that the bracket is centered.
After pressing the two velcro elements (upper and
lower strap) together, tuck the trailing ends of the
velcro under your helmet to avoid unsightly "ears. "
Grasp the bracket and move it back and forth with
moderate force, to make sure that it is firmly in place.
In doing this, thread the two straps through the
Wilma
2
2
2 9