Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Operation
Initialization; voltage display:
When you connect the light to the battery, the software runs a self-test,
during which all four status LEDs come on briefly.
The
battery voltage
is then shown via the blue and green LEDs,
as follows:
The blue LED blinks once for each volt; and then
the green LED blinks once for each 1/10 of a volt.
To see the battery voltage again, unplug the light from the battery
and then plug it in again.
For example,
if the blue LED blinks seven times and the green LED
then blinks five times, this means that the measured voltage under
load is 7.5 V.
This display helps you to assess the actual level of the
battery prior to use.
Guidelines in this regard:
More than 7.9 V: the battery is fully charged. 7.1 to 7.8 V: the battery
needs charging or is old. 6.5 to 7 V: the battery is not ready for use.
Note:
To deactivate this display, simply press the button. In other
words, you needn't let the display go through its whole cycle in order
to use the lamp.
The Power Control System (PCS) measures the voltage under load.
Thus measurements using a voltmeter will not be comparable.
34 Wilma
Switching on the light:
The first press of the button switches on the light with
power.
green LEDs will be illuminated.
Toggling between low and high beam:
To toggle between low and high beam,
When the light is on low beam, only the green LED is illuminated.
Initialization
Note:
airflow lowers the temperature of the light sufficiently. If the light is
not cooled by airflow, its power is reduced
the LEDs and electronic elements from overheating.
Switching the lamp off:
To switch off the lamp,
two seconds.
Battery voltage
SOS function:
To activate the SOS function, hold the button down for three seconds and then release it. If you don't
The battery level display
press the button again, the lamp will continue to emit the international SOS signal until the battery is
can also be seen in the
completely discharged. To deactivate the SOS function, press the button again. You can then use the
video on our Website
lamp in a normal fashion.
(click "Support").
Note:
visible for miles around and will continue flashing for hours if not shut off.
signal is punishable by law.
If the light is outputting maximum power, the blue and
press the button briefly.
The light outputs the maximum amount of light only if
incrementally
hold the button down
for more than
Use the SOS signal ONLY in an emergency. Thanks to the light's high luminance, the signal is
maximum
High beam setting
to prevent
Low beam setting
Improper use of the SOS
Wilma
3
35
Werbung
