Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
Programming the PCS
Tips for inexperienced programmers:
1. Keep calm
2. Read this section and the programming table
3. Determine
ahead
of time which steps you need to take to reach your goal. Whether these steps
are correct is indicated by the order in which the various LEDs are illuminated. It is advisable to
note down this order ahead of time so that everything goes according to plan.
Helpful hint:
To familiarize yourself with the programming procedure, it's best
to
start with stepless dimming
The three-phase dimming program is for advanced users only.
The Support section of our Website contains a series of videos that show you how to
program the PCS.
Note:
Always program the PCS with the light plugged into the battery.
Programming flowchart:
At
level 1,
which shows you the various programming options, select the function you'd like
to program:
Low/high beam
Battery warning signal
Power management
SOS function
Level 1
runs from left to right if the button is held down
in alternation at
four second
intervals or so.
4 2 Wilma
and then move on to two-phase dimming.
continuously,
and the LEDs come on
When the desired LED color and the attendant option is reached,
you to
level 2.
Here, you define the performance characteristics for the selected option.
Low beam/dimming:
Power management:
three-level (superflash)
Economy
two-level
Normal
three-level
Power
stepless
Battery warning signal:
SOS function:
Low
Int. SOS emergency signal
Middle
Alpine emergency signal
High
Superflash
Going through the options at this level makes the PCS run automatically,
a continuously illuminated LED in a specific color.
In other words,
release the button,
simply wait until the LED in the desired color comes on, and
THEN press the button again
to confirm your selection and exit automatic programming mode.
And that's it for level 2.
Now proceed to level 3 – but of course only if you wish to activate two or three level dimming
(low beam) and have pressed the button for the relevant LED in
define dimming intensity. The PCS programming options at this level likewise run automatically.
After the button has been released again, the LEDs (which now flash) allow you to select the desired
dimming level, i.e. 5 %, 13 %, 32 % or 53 %. To do this, again press the button when the LED showing
the desired percentage is displayed. And now you're done.
5
release the button,
which takes
Default setting
a state that is signaled by
level 2. Level 3
only enables you to
Wilma
43
Werbung
