Herunterladen Diese Seite drucken

Lupine Wilma Bedienungsanleitung Seite 19

Vorschau ausblenden Andere Handbücher für Wilma:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3
Operation
Discharged battery capacity:
When you shut off the lamp, the discharged battery capacity is shown
via flashing of the blue LED and then the green LED. This information can
only be displayed once as it is deleted when you unplug the battery.
The  blue LED blinks once for each Ah (ampere hour); and then
the  green LED blinks once for each 1/10 of an Ah.
For example, if the blue LED blinks four times and then the green LED
blinks six times, this means that 4.6 Ah were discharged from the battery.
Battery warning signal:
The battery level is shown via the yellow and red LEDs. If the battery voltage falls below a certain
level, the yellow LED turns on (the light also flashes once). The red LED flashes just before the
battery is completely discharged.
Safety advisory: When the battery is completely discharged, the yellow and red LEDs flash
in alternation for a few minutes and the light will shut down after flashing a few times. In such
a case, you should stop riding your bicycle immediately.
Low capacity remaining
Very low capacity remaining
(level 1)
36 Wilma
Discharged capacity
Stop immediately.
(level 2)
Note:
The battery time remaining after the
yellow or red LED
capacity, the ambient temperature, the battery's age, and whether you use the low, middle or high
setting. Moreover, since the voltage curve of a Li-Ion battery is not proportional to the power left in
the battery, you need to learn how to interpret the relevant displays for your specific battery.
Reserve power:
When the battery is completely discharged, the yellow and red LEDs
flash in alternation for a few minutes and the light shuts down after
flashing a few times. To activate the battery's reserve power, double-
click the switch. This will give you a few minutes more light, whose
exact amount depends on the age of your battery. The light emitted in
reserve-power mode is less than 6 W so as to conserve power and keep
the light going as long as possible. The red LED flashes when reserve-
power mode is activated.
When the reserve power has been completely
discharged, the light will shut down – which means that you need to
ride slower.
Note:
If only 1 W is used, reserve power is not available.
Safety advisory:
Do not switch on the light when the battery
is discharged, as this will invariably
damage the battery.
Recharge the battery as soon as possible to avoid a deep
discharged battery.
3
flashes depends on total battery
Reserve power
Wilma
37

Werbung

loading

Diese Anleitung auch für:

Wilma 6Wilma 12Wilma xWilma x pro