Safety Precautions In Normal Operation; Safety Inspection; Alterations To The Calibration System; Spares And Wearing Parts - Fronius 4000 R Bedienungsanleitung

- By means of internal instructions and checks, ensure that the workplace
and the area around it are always kept clean and tidy.

SAFETY PRECAUTIONS IN NORMAL OPERATION

- Only operate the calibration system if all its protective features are
fully functional.
- Before switching on the calibration system, ensures that nobody can
be endangered by your turning on the machine.
- At least once a week, check the calibration system for any damage
that may be visible from the outside, and check that the safety
features all function correctly.

SAFETY INSPECTION

The owner/operator is obliged to have the calibration system checked for
correct functioning by a trained electrician after any alterations,
installations of additional components, modifications, repairs, care and
maintenance, and in any case at least every six months.
In the course of such inspection, the following regulations must be
observed (as a minimum):
- VBG 4, §5 - Electrical plant and apparatus
- VDE 0701-1 - Corrective maintenance, modification and testing of
electrical equipment

ALTERATIONS TO THE CALIBRATION SYSTEM

- Do not make any alterations, installations or modifications to the
calibration system without getting permission from the manufacturer
first.
- Replace immediately any components that are not in perfect condition.

SPARES AND WEARING PARTS

- Use only original spares and wearing parts. With parts sourced from
other suppliers, there is no certainty that these parts will have been
designed and manufactured to cope with the stressing and safety
requirements that will be made of them.

CALIBRATING THE CALIBRATION SYSTEM

In view of international standards, regular calibration of the calibration
system is advisable. Fronius recommends a 12 month calibration interval
For more information, please contact your Fronius partner!

CE-MARKING

The calibration system fulfils the fundamental requirements of the Low-
Voltage and Electromagnetic Compatibility Directive and is thus CE-
marked.

COPYRIGHT

Copyright to this instruction manual remains the property of Fronius
Schweissmaschinen Vertrieb GmbH & CoKG.
Text and illustrations are all technically correct at the time of going to
print. Right to effect modifications is reserved. The contents of the
instruction manual shall not provide the basis for any claims whatever on
the part of the purchaser. If you have any suggestions for improvement,
or can point out to us any mistakes which you may have found in the
manual, we should be most grateful.
5