Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the "FastFreeze" or
"Shopping", or after chang‐
ing the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The "FastFreeze function"
or "Shopping function" is
switched on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Food products prevent the
water to flow into the wa‐
ter collector.
The water outlet is clog‐
ged.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The "FastFreeze function"
or "Shopping function" is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
Solution
Refer to "FastFreeze function"
or "Shopping function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Refer to "Operation" .
The compressor starts after a
period of time.
This is correct.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func‐
tion" or "Shopping function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"Shopping function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
31
Werbung
