ABS A.LIGHT E Bedienungsanleitung Seite 57

7
ON / OFF AND AUTO-TEST
a To turn on the E2 System, use the ON / OFF
switch. This safety switch prevents undesired
activation inside the bag. Pull the switch up, turn
it clockwise and hold for 2 seconds.Each time it
is turned on, the E2 System conducts an auto-
test to verify that the motor, SuperCapacitors
and electronics are functioning properly. During
this self-test, the 3 LEDs light up chronologically
to check that the LEDs are functioning.
Simultaneously, the LCD display blinks to check
that the LCD display is working properly and all
icons are visible.
56
a During this auto-test, the motor completes a
first rotation at low speed, switching on the
green LED.
a If the auto-test is succesfully completed, the
motor rotates a second time and the green /
orange LED will blink
>The system is ready for use.
a If the auto-test detects a malfunction, the
motor will rotate 4x and the red LED will
remain on There is a problem in the system
and it is not operational.
a If the system detects a malfunction and it is
charging, the red LED will remain on and
the orange LED will blink rapidly.If there is
a failure during the self-test, the following
icon will be displayed on the LCD:
a To turn the system OFF, pull the switch and
turn it clockwise (same procedure as for
turning ON). The motor will rotate 1 x and
the red LED will turn on and off again to
indicate that the system has shut down.