Sharp XV-320P Serviceanleitung Seite 2

ae iat ee en ot oe
| XV-320P©
rr -
XV-320P |
System:
Projection image size
(diagonal):
LCD panel:
No. of pixels:
Lens:
Contrast ratio:
Horizontal resolution:
Operating temperature:
Storage temperature:
Power source:
Audio output:
Speaker:
Power consumption:
Dimensions (WxHxD):
Weight:
Accessories:
* PARA RAH -I- '. or bog or ot . fac3 ety ;
SECAM Mode is only available if the projector is indicated with a © mark on the label
at the bottom side.
NOTE
| ada —
XV-320P©
WM RWN
enclosure removed.
described below and handle the lamp with care.
M Lamp Replacement
Note:
Since the lamp reaches a. very high temperature during
units operation replacement of the lamp should be
done at least one hour after the power has been
turned off. (to allow the lamp to cool off.)
Installing the new jamp, make sure not to touch the
lamp (bulb) replace the lamp by holding its reflector
@.
[Use original replacement only.]
@) Reflector
DANGER ! — Never turn the power on without the lamp to avoid electric-shock or
damage of the devices since the stabilizer generates high voltages at its start.