ims PRO GENFEED 4L Bedienungsanleitung Seite 19

- Turn one of the two knobs
- The display indicates a memory set (01 to 50) while blinking.
- Turn one of the two knobs to select the memory slot containing the settings to load. Validate by pressing the button
The settings are loaded / the menu exit is instantaneous.
Quick Load mode: Easy recall of saved welding parameters :
When the « Quick load » mode
the trigger. Slots 2 to 50 can store customisable welding parameters. (Example : Setting 5 will allow the user to recall, using he trigger, programs 01
to 05).
WELDING CYCLES
2T mode:
Trigger
Held
Released
Gas
Wire speed
Voltage
: If the Hotstart phase feature is deactivated, the welding starts immeditately after the arc ignition (Start).
(1)
: If the Crater Filler feature is deactivated, the wire is drawn back immediately after the trigger is released.
(2)
GENFEED 4L
. Validate by pressing the button
is active, the user can sequentially recall previously saved welding parameters, by briefly pressing/releasing
Hotstart
(1)
.
Welding Crater Filler
(2)
EN
.
19