Yamaha MT120S Bedienungsanleitung Seite 8

@ AUX SEND Controls
@ AUX RETURN Control
@ MONITOR SELECT Switch
© MONITOR Controls 1 — 4
@ MONITOR/PHONES Control
® MASTER Fader
The MASTER fader sets the overall output level of the
MT120S mixer section, and thus the level of the output
signal appearing at the STEREO OUT jacks. The MAS-
TER fader also affects recording level when any of the
mixer section's channels are assigned to the record-
er's tracks via the PAN controls (see "SETTING RE-
CORDING LEVELS" on page 15).
® LED Peak Meters
The four LED peak meters еш display ойр
levels from the MT120S's four recorder tracks when
the METER switch is set to "АТВ", or meters 1 and 2
display the level of signals appearing at the mixer
section's stereo outputs (the STEREO OUT jacks) when
the METER switch is set to *ST."
The LED peak meters are a guide for setting up те);
optimum recording levels. (see "SETTING RECORD
ING LEVELS" on page 15).
(B METER Switch
When the METER switch is set to "ST," meters 1 and 2
display the level of signals appearing at the mixer
section's stereo outputs (the STEREO OUT jacks). When
set to "4TR," the four LED peak meters display the
level of the corresponding recorder track signals.
(D dbx ON/OFF Switch
The dbx switch determines whether the MT120S 's
internal dbx noise reduction system is ON or OFF. For
normal recording and playback using the MT120S, the
dbx switch should be turned ON. This provides a sig-
nificantly improved signal-to-noise ratio (as much as
. 85 dB) so your recordings will sound cleaner and have
much less tape hiss.
If dbx noise reduction is to be activated during 6),
recording, set the switch to "SYNC".
For dbx noise reduction to be effective, it must be
turned ON both during recording and playback.
The dbx switch may be turned OFF when playing back
tapes that were recorded on other equipment and which
are not dbx-encoded.
"For Error-free SYNC Recording"